Install the Aysali SMS Android app and connect it to your workspace SMS Gateway. The recommended path is one-step QR pairing from the tenant portal.

Before you start

• An Android phone with a SIM (dedicated device preferred)
• Access to the tenant portal SMS Gateway page
• SMS Gateway enabled and active on your plan

Step 1 — Download and install the APK

1. In the portal, open SMS Gateway → Status.
2. Tap Install app and download the APK on the phone, or use:
   • Download Aysali Android APK
3. Allow installation from unknown sources if Android prompts you.
4. Open the app after install completes.

1. •

   Use a dedicated phone when possible

   SMS delivery works best on a device with a stable SIM and network.

2. •

   Grant SMS permissions

   The app needs permission to send and read SMS for gateway operation.

Step 2 — Show the pairing QR in the portal

1. On a computer (or another screen), open SMS Gateway → Status.
2. Tap Connect with QR.
3. Keep the large dialog open — it shows the pairing code and short instructions.
4. Do not share screenshots of this dialog publicly; it contains account secrets.

Step 3 — Scan from the Android app

1. On the phone, open the Aysali SMS app.
2. Go to Settings → Cloud server.
3. Tap Connect with QR.
4. Allow camera access when prompted.
5. Scan the code shown in the portal dialog.
6. Wait until the app confirms a successful connection (success dialog).

The app applies the server details and registers the device automatically.

Step 4 — Confirm on Home

1. Return to the Home tab (the app may switch there after you confirm success).
2. Cloud server should appear enabled with your account details.
3. The connection starts automatically after a successful QR pair when permissions are granted.
4. Wait until status shows Online.

Verify success

Setup is complete when:

• App status is Online
• The device appears in SMS Gateway → Devices in the portal
• A test message sends successfully (portal or API)

Manual fallback (optional)

If you cannot use the camera, enter API URL and Private Token manually under Settings → Cloud server (values from the portal Status tab), then enable Cloud server on Home and start the service. QR pairing remains the preferred path.

If status stays offline

See Troubleshooting — common causes are unreachable API URL, camera/scan failure, or gateway health issues. Try Connect with QR again from the portal.

Next step